Publicité
Les langues disponibles
Les langues disponibles
Dryer
FAQs: Frequently Asked Questions
Q:
When I press a button, why does my dryer beep and then nothing happens?
A:
The Control Lock feature is turned on. To turn off Control Lock, turn the dryer on, then press and
hold the button that has Control Lock on or under it for 3 seconds.
Q:
Why does my dryer take so long to dry clothes?
A:
Proper airflow is critical to the efficient operation of clothes dryers. A lint filter which is full of lint or
clogged with fabric softener sheet residue can reduce the airflow to the point that the time required
to dry clothing will be greatly increased.
Q:
Why does my dryer start by itself every few minutes?
A:
This is how the Wrinkle Care feature works. The dryer runs briefly every few minutes for up to 3
hours after the cycle finishes. This feature is designed to help prevent wrinkles from setting in when
the dryer is not unloaded immediately after the cycle is finished.
Error Messages
Problem
tE1
tE7
Temperature sensor failure.
through
• Turn off the appliance and call for service.
TEMPERATURE
SENSOR ERROR
Ps
Power cord is connected incorrectly.
• Check the connection of the power cord to the terminal block.
POWER ERROR
d7s
d8O
dGO
dGs
The duct work is about 75% - 95% blocked. (The error code is displayed for 2 hours only.)
,
,
,
• Do not use the appliance until the exhaust system has been cleaned and/or repaired.
DUCT BLOCK ERROR
• Check the outside dryer vent while the appliance is operating to make sure there is strong
House exhaust system blocked.
• Keep the area around the dryer clean and free of clutter. Check vent hood for damage or
The Control Lock function is on to prevent anyone from changing cycles or operating
[L
the dryer.
CONTROL LOCK
• Turn off the Control Lock function in the control panel. See Control Lock under Options
FUNCTION
Operation
Problem
TM
The Flow Sense
After clearing the restrictions, the Flow Sense
W
consecutive cycles to determine that the performance value has improved before the
(
) indicator
remains active after
Flow Sense
clearing the
• If the Flow Sense
restriction in the
venting.
Using the appliance with a severely restricted exhaust is dangerous and could result in a
fire or other property damage.
airflow. If the exhaust system is extremly long, have it repaired or rerouted.
lint clogging. Make sure the area around the vent hood is clear.
and Extra Functions.
TM
W
(
) indicator is reset.
TM
W
(
) indicator remains active for more than five cycles after the
restriction has been cleared, call for service.
Possible Cause & Solution
Possible Cause & Solution
TM
W
(
) system requires multiple,
TROUBLESHOOTING
51
Publicité
