Jennair JJB6424HM Guide D'utilisation page 20

DISPLAYED MESSAGE
INSERT GROUND
CONTAINER AND DRIP
TRAY
INSERT WATER OUTLET
WATER CIRCUIT EMPTY
PRESS OK TO START
FILLING PROCESS
PRESS OK TO START
CLEANING PROCESS OR
TURN MILK FROTH
ADJUSTMENT KNOB
OK
20
POSSIBLE CAUSE
After cleaning, the grounds container has not
been replaced.
The hot water spout is not inserted or is inserted
incorrectly.
The water circuit is empty.
The milk container has been inserted with the
froth adjustment dial in the CLEAN position.
REMEDY
Remove the drip tray and insert the grounds
container.
Insert the water spout as far as it will go.
Press OK and allow fresh water to drain out of the
spout; the flow will stop itself automatically. If the
problem persists, make sure the water tank is fully
inserted.
To proceed with the CLEAN function, press
or turn the froth adjustment dial to one of the milk
positions.
OK