Jennair JJB6424HM Guide D'utilisation page 19

DISPLAYED MESSAGE
GENERAL ALARM:
REFER TO USER
MANUAL
SELECT A MILDER
TASTE OR REDUCE
PRE-GROUND COFFEE
QUANTITY
ESC
GROUND TOO FINE.
ADJUST GRIND
LEVEL 1 CLICK WHILE IN
OPERATION
INSERT BREWING
UNIT
INSERT MILK
CONTAINER
POSSIBLE CAUSE
The inside of the coffee system is very dirty.
Too much coffee has been used.
The grinding is too fine and the coffee is
delivered too slowly or not at all.
If the water filter is present, an air bubble
may have been released inside the circuit,
obstructing delivery.
After cleaning, the infuser has not been
replaced.
The milk container is not inserted correctly.
REMEDY
Clean the inside of the appliance thoroughly, as
described in the "Cleaning" section. If the message
is still displayed after cleaning, contact an authorized
Customer Service Center.
Select a milder taste by pressing
the quantity of pre-ground coffee (maximum one
measure).
Repeat coffee delivery and turn the grinding
adjustment dial one click clockwise towards number
seven while the coffee mill is in operation. If after
making at least two coffees delivery is still too slow,
repeat the correction procedure, turning the grinding
adjustment dial another click. If the problem persists,
make sure the water tank is fully inserted.
Insert the hot water/steam spout in the appliance
and deliver a little fresh water until the flow becomes
regular.
Insert the infuser as described in the "Cleaning the
Infuser" section.
Insert the milk container as far as it will go.
or reduce
19