Gentilin CS 240/03 Manuel D'instructions page 37

Although the Manufacturer has adopted all technical construction solutions in order to make the appliance as safe as
possible, authorised operators please be aware that residual risks remain.
RESIDUAL RISK
SEVERITY OF DAMAGE
LIABILITY
PROBABILITY
PHASE IN WHICH THE
RISK IS PRESENT
SUITABLE PROVISIONS
23. AREAS ASSUMED BY AUTHORISED OPERATORS
AREA A: on the rear side of the appliance
next to the command devices , in order
to command the activation and deac-
tivation of the compressor, to carry out
connection/disconnection of the utensils,
reading of the gauge and the regulation
of the pressure, cleaning or replacement
of the air filter and opening/closure of the
condensate pump.
AREA B: when working to carry out suita-
ble operation dependent on the type of
utensil used (E.g. veneering, etc.).
The command devices are:
1
Air outlet spigot
2
Outlet pressure regulator
3
"ON-OFF" switch
4
Pressure switch
5
Electrical supply cable
6
Tank outlet gauge
7
Tank pressure gauge
Rev. 00 - 12/2013 - Cod. CM31710 - Instruction manual
22. RESIDUAL RISKS
Danger of burns upon accidental contact with the twin cylinder pump system
and the electric motor.
Mild damage (normally reversible).
Liability may be incorporated in the instance when the operator decides to
voluntarily carry out an incorrect or forbidden action.
Small and accidental.
Operation.
Safety signs (see Paragraph 20).
Commitment to use personal protection equipment (PPI) (see Paragraph 21)
and/or waiting for the appliance to cool.
24. COMMAND DEVICES
1 2
7
Compressor Mod. CS240
3 4
6 5
15