OHAUS Frontier FC5513L Manuel D'instructions page 20

TM
Frontier Centrifuge FC5513, FC5513R, FC5513L
A-1
3.5.3 Leaving program mode
To leave the program mode just press the key "Prog/Setup" (3) (refer to figure 22). Then inside the display
"Time/Prog" (A-3) the word "programm"(M10) appears.
Set the display to "programm--" (M10) with the adjusting dial (4).
3.6 Starting and stopping the centrifuge
3.6.1 Starting the centrifuge
You can start the centrifuge either with the "Start" key (10) (refer to figure 21) or the "Quick Spin" key (8).
By the "Start" key (10) you can start stored runs or runs with manually pre-selected parameters.
When the respective pre-selected running time has ended the centrifuge will stop automatically.
By the "Quick Spin" key (8) you can start runs, which will last just a few seconds.
By pressing the "Quick Spin" key (8) the centrifuge accelerates up to the pre-selected revolution.
In the display "Time/Prog" (A-3) the passed running time is indicated from the date of pressing the "Quick Spin"
key (8).
By releasing the "Quick Spin" key (8) the centrifuge stops and the running time is indicated until the opening of the
lid.
3.6.2 The "STOP/Lid" key
By the "Stop/Lid" key (9) (see figure 24) you can interrupt the run at any time. After pressing the key, the
centrifuge decelerates with the respective pre-selected intensity down to stand still. After the rotor complete
stopped, press the "Stop/Lid" key will open the lid.
M3 M4
Figure. 22
A-3
Figure. 23
A-3
M10
3
4
2
3
10
8
EN-15