HBM QUANTUM X SCM-HV Guide De Démarrage Rapide page 3

SCM-HV
1 Safety instructions
A3615-1.0_en/de/fr
Intended use
The SCM­HV (signal conditioner) is only used to meas­
ure the differential voltages within the ratings stated in
the Specifications, in conjunction with a suitable Quan­
tumX module.
The signal conditioner is designed for use in clean and
dry rooms, and cables must not be routed through out­
door areas either. It must not be operated where dust
levels or the moisture content of the air are particularly
high, where there is a risk of explosion, or in an aggress­
ive chemical environment.
See the specifications for the permissible ambient tem­
perature, as well as the permissible storage and trans­
portation temperatures. Should condensation have
formed during transportation, the SCM­HV must be accli­
matized for approx. 2 hours, before being put into opera­
tion.
The signal conditioner must only be operated on suitable
QuantumX modules (see specifications) — it is not ac­
ceptable to apply measuring voltage when the signal con­
ditioner is not connected. The operating position is op­
tional.
Everyone involved with siting, starting up, or operating
the signal conditioner must have read and understood
the operating manual and in particular the technical
safety instructions.
In the interests of safety, the signal conditioner should
only be operated by qualified personnel (see below) and
as described in the operating manual. It is also essential
to comply with the legal and safety requirements for the
3