HBM QUANTUM X SCM-HV Guide De Démarrage Rapide page 20

20
sources that are subject to interference or highly
dynamic.
- Do not lay measuring leads next to potentially inter­
fering devices, such as motors, inverters, etc.
DANGER
S The SCM­HV must only be connected to the 15­pin
sockets of the QuantumX modules suitable for opera­
tion with the SCM­HV.
S The signal conditioner must only be put into operation
once it has been connected and locked with the two
knurled nuts.
S The SCM­HV is specified according to EN 61010 for
300 V CAT II. Only accessories approved for at least
this category can be used and connected at the
measuring connections. This also applies to exten­
sions of the measuring lead.
SCM-HV
A3615-1.0_en/de/fr