Cable Lock - Zephyr Roma Groove ZRG-E30AS Guide D'utilisation, D'entretien Et D'installation

Installation Instructions
9. Hang the hood onto the mounting screws and hand tighten each screw. (FIG. A)
10. Center and attach the duct cover mounting bracket to the wall just below the ceiling or soffit using
(2) M6 x 1" screws.
11. Install the electrical and duct work. Seal the duct work with aluminum duct tape.
12. Power up the hood and check for leaks around the duct tape.
13. Place the telescopic duct covers onto the hood and extend the inner (top) duct cover upwards.
Secure it to the duct cover bracket using (2) M4 x 8 screws.
NOTE: If using the hood in recirculating mode, you must secure the air diverter plate onto wall before
installing duct work and duct covers. You will also need to install charcoal filters and brackets.
Turn to page 19 for more details.

Cable Lock

accordance with all applicable codes and standards. This range
hood must be properly grounded. Turn off electrical power at
A cable locking connector (not supplied) might be required by local codes. Check with local
requirements and codes, purchase and install appropriate connector if necessary. (FIG. B)
18
WARNING
Electrical wiring must be done by qualified person(s) in
service entrance before wiring.
Cable Lock
Roma Groove Use, Care, and Installation Guide
FIG. B
C O R E
R O M A G R O O V E
WA L L