Cable Lock - Zephyr ZAN-E24CS Guide D'utilisation, D'entretien Et D'installation

!
CAUTION: At least two installers are required
due to the weight and size of the hood.
ZAN : 18-7/16" from line A
ZSA : 9-1/2" from line A
ZRV : 15-7/8" from line A
ZRO : 11-3/8 from line A
ZAN : 8-7/8" on line B
ZSA : 9-7/8" on line B
ZRV : 8-15/16" on line B
ZRO : 12-5/8" on line B
the way. Note: Wood blocking may need to be added behind the
drywall if no studs are present. Wall anchors may also be used
but check local codes for compliance. Failure to use suitable wall
anchors and screws to hold the weight of the hood could result
in personal injury or damage to the cooking surface or counter.
7. Hang hood onto the mounting screws and hand tighten each screw.
tape.
12. ZRV : Lilft glass canopy and place on top of hood body, secure glass
* If using hood in recirculating mode you must secure the air diverter
more details.
!
WARNING: Electrical wiring must be done by a qualified person(s) in
accordance with all applicable codes and standards. This range hood must be
properly grounded. Turn off electrical power at service entrance before wiring.

Cable Lock

install appropriate connector if necessary.
12
www.zephyronline.com
26" min.
FIG. A
Cable Lock