Information On Display Panel; Temperature Problem; Noise - Siemens KI I Série Notice D'utilisation

Fault
The refrigeration unit is
switching on more fre-
quently and for longer.
The base of the refrigerator
compartment is wet.

Information on display panel

Fault
The temperature display
flashes.

Temperature problem

Fault
The temperature differs
greatly from the setting.

Noise

Fault
Appliance has a humming
sound.
The appliance bubbles,
buzzes or gargles.
Cause
The appliance door was
opened frequently.
The ventilation openings are
covered up.
The condensation channel
or drainage hole are
blocked.
Cause
The appliance door was
opened frequently.
Larger quantities of fresh
food have been put in.
The ventilation openings are
covered up.
Cause
Different causes are pos-
sible.
Cause
Not a fault. A motor is run-
ning, e.g. refrigerating unit,
fan.
Not a fault. Refrigerant flows
through the pipes.
Troubleshooting en
troubleshooting
Do not open appliance door unne-
▶
cessarily.
Remove any obstructions from in
▶
front of the ventilation openings.
Clean the condensation channel
▶
and the drainage hole. → Page 47
troubleshooting
Do not open appliance door unne-
▶
cessarily.
Switch on Super freezing before
▶
placing a larger amount of food in
the appliance.
→ "Switching on Super freezing",
Page 42
Remove any obstructions from in
▶
front of the ventilation openings.
troubleshooting
Switch off the appliance.
1.
→ Page 41
Switch the appliance back on after
2.
five minutes. → Page 41
If the temperature is too
‒
warm, check the temperature
again after a couple of hours.
If the temperature is too cold,
‒
check the temperature again
on the following day.
troubleshooting
No action required.
No action required.
49