Publicité
Les langues disponibles
Les langues disponibles
3. Place the device on a dry, heat-resistant, fl at surface with suffi cient clearance on all
sides and above (around 30 cm).
4. Insert the mains plug into a properly installed 230 V plug socket. Make sure that the
cable is not trapped between the grill surfaces! Move the temperature control to
the highest setting and allow the device to heat up for around 5 - 10 minutes to re-
move any possible production residues.
5. Switch the device off by pulling the mains plug from the mains socket.
6. Allow the device to cool down and then clean it again with a soft kitchen towel and a
little mild detergent. Then dry the device well.
Use
CAUTION!
❐ Caution: Danger of burns! The device will become hot during use. Make absolutely
sure that you do not come into contact with any heated parts such as the housing or
the grill plate during and after use of the device. Only touch the device by the han-
dles provided and use oven cloths or kitchen gloves when handling the device. Only
clean, transport and store away the device after it has cooled down completely.
❐ If you have burnt yourself on a hot surface, cool the spot immediately with cold water
and consult a doctor immediately to get treatment for the burn.
❐ When opening the device, keep a suffi cient distance to prevent burns caused by heat
or hot steam.
❐ The device should only be used and stored out of the reach of children. The mains
cable must also be kept out of the reach of children.
❐ Never use the device without the fat collecting tray. Cooking fat runs out of the fat
drain on the back of the device when it is used! Always insert the fat collecting tray
into the device before it is used!
•
The device is suitable for grilling and frying fi sh, meat and vegetables and
for preparing toasted sandwiches etc.
•
The device can be uses as a closed contact grill as well as an open table-
top grill.
1. Place the closed grill on a stable, even, heat-resistant surface.
2. Insert the fat collecting tray into the bottom of the housing.
3. Connect the device to a properly installed plug socket. The operating lamp lights up
as soon as the device is connected to the mains power. Make sure that the cable
does not come into contact with hot surfaces during use.
4. Move the temperature control to the MAX position to preheat the device. The preheating
process lasts about 5 minutes. The device has reached operating temperature when
the heating control lamp lights up. Please note that during the grilling process the
heating control lamp may go out and then light up again at regular intervals as the
device reheats and then stops heating in order to maintain a constant temperature.
5. Now use the temperature control to set the device to the temperature setting you want.
All manuals and user guides at all-guides.com
17
Publicité
