Publicité
Les langues disponibles
Les langues disponibles
Then take the rear stabiliser bar (11A)
and carry out the same assembly
operation as with the front stabiliser
bar, tighten up all of the nuts (12)
securely.
4. ATTACHING THE SADDLE.-
Remove screws (16) and washers
(22) from the bottom of the saddle
(01). Fit the saddle (01) in the
direction of the arrow, Fig.4, onto the
saddle post plate (23), making sure
that the holes in the saddle post are
facing the front part of the saddle, and
tighten the nuts securely.
5. FITTING THE BACKREST
SUPPORT.-
Position de backrest "U" (17) in the
saddle post (23) Fig.5, fit the screws
(10) with the washers (22) and tighten
with the nuts (16).
6. FITTING THE BACKREST.-
Position the backrest (21) in the
support (17) Fig.6.
Fit it with the screws (18) and washers
(19) Fig.6.
Next, insert the saddle post into the hole
(A) Fig.7, on the main body (07), fit the
saddle post adjustment knob (14),
adjust the position of the saddle post
and tighten the knob (14) by turning it
clockwise.
7. FITTING THE SADDLE
HANDGRIP.-
Position the handgrip (20) in the
support (17) Fig.6. Insert the screws
(15), along with washers (9) and nuts
(16) and tighten securely.
8. FITTING THE HANDLEBAR.-
Bring the handlebar (03) up to the
handlebar stem (07), slot as shown in
Fig.9, refit the screws (4), the washers
(5)
and
(6),
securely.
9. ATTACHING THE PEDALS.-
The assembly instructions for the
pedals must be followed to the
letter, fitting these incorrectly could
damage the screw thread on the
pedal or the crank.
Right and left refer to the position that
the user adopts when sitting on the
saddle to do the exercises.
The right pedal (08) is marked with the
letter (R).This screws onto the right-
hand crank, also marked with an (R),
in a clockwise direction. Tighten
securely Fig.10.
The left pedal (13) is marked with the
letter (L).This screws onto the left-
hand crank, also marked with an (L),
in an anti-clockwise direction.
Tighten securely Fig.10.
10. EXERTION SETTINGS.-
To provide an even level of exertion
during exercise, this appliance is
equipped with a tensioning control
(37), located on the main post, offering
various exertion settings, Fig.11.
To increase pedal resistance turn the
tensioning control (37) clockwise (+)
until the exertion level best suits your
exercise requirements. To reduce
pedal resistance turn the tensioning
control (37) anticlockwise (-).
11. STORAGE
If you want to store your unit in
minimum space, follow the next steps.
Fold up the unit (07) following the
arrows. Place the safety pin (47) in its
housing, as shown in Fig.12.
12
Fig.9,
and
tighten
Publicité
