Blackstone 1939 Manuel Du Propriétaire page 8

OWNER'S MANUAL | USING YOUR BLACKSTONE
Proceed to USING YOUR BLACKSTONE�
STEP 11
NOTICE
• DO NOT mix old and new batteries.
• DO NOT mix alkaline, standard (carbon-zinc) or rechargeable
(ni-cad, ni-mh, etc.) batteries.
NEVER leave oil exposed in the rain. This can lead to severe
burns.
Place the included hardcover on the burner when not in use
or if it begins to rain.
Grease build-up on the Flame Tamper can catch fire when
heated.
To prevent damage to the unit and/or injury, clean the top of
the Flame Tamper after each use.
NOTICE
DO NOT sit or stand on the table.
USING YOUR BLACKSTONE
CoNNeCT THe lPG CYlINdeR
1 LB (453 G)
screw in the lPG cylinder into the gas regulator, turning the
STEP 01
cylinder clockwise�
The regulator may make a humming or whistling noise during operation. This The regulator may make a humming or whistling noise during operation. This
will not affect safety or use of the appliance. will not affect safety or use of the appliance.
08
CAUTIoN
CAUTIoN
NOTICE
DO NOT leave the hood closed for more than 10 minutes while
cooking.
NOTICE
• Maximum weight on the side shelf is 10 lbs (4.5 kg).
• The side shelf may get hot while appliance is in use.
Handle will get hot while appliance is in use.
DO NOT touch the handle while appliance is hot.
NOTICE
• Maximum weight on the tabletop is 100 lbs (45 kg).
• Maximum weight on the inner shelf is 50 lbs (22.5 kg).
• Maximum weight on the side shelf is 10 lbs (4.5 kg).
REGULATOR SAFETY
Cross threading can occur if you force thread a connection
at an improper angle. This will damage the threads, lead to
propane leaking, and potentially result in a build-up of fuel
that can ignite.
DO NOT cross thread the connection between your LPG
cylinder and regulator or regulator and gas rail.
If you can not connect the regulator, DO NOT use the
regulator.
Regulator must be replaced with a Blackstone approved
model by a professionally licensed, authorized dealer.
Use this appliance, as purchased, only with gas and regulator/valve
assembly supplied�
If regulator fails in unit, it must be replaced with a Blackstone approved model If regulator fails in unit, it must be replaced with a Blackstone approved model
(found on your Manufacturer label) by a professionally licensed, authorized (found on your Manufacturer label) by a professionally licensed, authorized
dealer. Failure to comply will void the warranty. dealer. Failure to comply will void the warranty.
Models: 1939 • 1945
CAUTIoN
WARNING
WARNING
BLACKSTONEPRODUCTS.COM/SUPPORT