Blackstone 1939 Manuel Du Propriétaire page 7

Models: 1939 • 1945
ensure that the ignition needle is set 3-7mm above the
STEP 07
burner tube�
Make sure the front pins are fully
seated in the holes, then push
the griddle top forward to lock
the griddle in place�
Make sure the front pins are fully
seated in the holes, then push
the griddle top back to lock the
griddle in place�
Use the two (2) M6 screws and grommets pre-installed in
STEP 09
the handle to install the handle to the front of the hood�
Place the two front pins into the
front locking holes and push the
griddle top and hood back� Then,
set the two rear pins into the
rear holes�
BLACKSTONEPRODUCTS.COM/SUPPORT
3-7mm 3-7mm
ASSEMBLY GUIDE
place the griddle top on the main body by aligning the 4 pins
STEP 08
to the holes of the body�
Make sure the front pins are fully
seated in the holes, then push
the griddle top forward to lock
the griddle in place�
Make sure the front pins are fully
seated in the holes, then push
the griddle top back to lock the
griddle in place�
Hang the grease cup in the slot on the back of the
STEP 10
griddle body�
Place the two front pins into the
front locking holes and push the
griddle top and hood back� Then,
set the two rear pins into the
rear holes�
| OWNER'S MANUAL
07