Maytag Commercial MAT24PD Instructions page 11

2. To avoid damaging floor, place cardboard supports from
shipping carton on floor behind washer. Tip washer back
and place on cardboard supports. Remove shipping base.
Set washer upright.
IMPORTANT: Removing shipping base is necessary for proper
operation.
NOTE: Keep shipping base in case you need to move washer
later.
3. Remove tape from washer lid, open lid, and remove cardboard
packing tray from tub. Be sure to remove all parts from tray.
NOTE: Tray must be removed prior to plugging the washer
into an outlet. Keep tray in case you need to move washer
later.
POWER CORD REPLACEMENT
INSTRUCTIONS
The steps in this section shall only be performed by a Maytag
service person, qualified electrician, or similarly qualified person.
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
1. The appliance shall be disconnected from the power
supply before servicing. Read all instructions before any
disassembly.
2. Remove retaining screw securing power cord assembly to the
product and save for re-installation.
Retaining
Screw
3. Rotate the power cord strain relief bracket within the machine
console and remove at an angle from the opening in the
back panel to expose access to the inner connector. The
inner connector is still connected. Do not put strain on the
conductors while removing the bracket to allow access to the
connector.
Twist
Remove at
Angle
Outside Product
4. Disengage the supply connection within the product by
depressing the connector clip to release the power cord from
the appliance.
Press
Inside Product
11