Connecting the drain hose
! We advise against the use of hose extensions;
if it is absolutely necessary, the extension must
have the same diameter as the original hose
and must not exceed 150 cm in length.
Electrical connections
Before plugging the appliance into the
electricity socket, make sure that:
• the socket is earthed and complies with all
applicable laws;
• the socket is able to withstand the maximum
power load of the appliance as indicated in
the Technical data table (see opposite);
• the power supply voltage falls within the
values indicated in the Technical data table
(see opposite);
• the socket is compatible with the plug of the
appliance. If this is not the case, have the
socket or the plug replaced.
! The machine must not be installed outdoors,
even in covered areas. It is extremely
dangerous to leave the appliance exposed to
rain, storms and other weather conditions.
! The mains socket must remain within easy
reach after the Washer-dryer has been installed.
Connect the drain
hose to drain duct
piping or a wall drain
located between 65
and 100 cm above
the floor, making sure
it is not bent at all.
Alternatively, rest the
drain hose on the
side of a washbasin
or bathtub, fastening
the duct supplied to
the tap (see figure).
The free end of the
hose should not be
underwater.
! Do not use extension cords or multiple sockets.
! The cable should not be bent or compressed.
! The power supply cable and plug must only
be replaced by authorised technicians.
Warning! The company shall not be held
responsible in the event that these regulations
are not respected.
Technical data
Model
AQD1071D 69
width 59.5 cm
height 85 cm
Dimensions
depth 64.5 cm
from 1 to 10 kg for the wash
programme
Capacity
from 1 to 7 kg for the drying
programme
please refer to the technical
Electrical
data plate fixed to the ma-
connections
chine
maximum pressure
1 MPa (10 bar)
Water con-
minimum pressure
nections
0.05 MPa (0.5 bar)
drum capacity 71 litres
up to 1600 rotations per
Spin speed
minute
Wash: programme
perature 60°C; using a load
of 10 kg.
Energy ra-
Drying: the smaller load
ted
(3kg) must be dried by se-
programmes
lecting the "Hanger" dryness
according to
level. The load must consist
regulation
of 3 sheets, 2 pillowcases
and 2 hand towels;
EN 50229
the remainder of the load
must be dried by selecting
the "Extra" dryness level.
This appliance conforms to
the following EC Directives:
- 2004/108/EC (Electroma-
gnetic Compatibility)
- 2006/95/EC (Low Voltage)
- 2012/19/EU (WEEE)
EN
; tem-
3