Publicité
Les langues disponibles
Les langues disponibles
Operation
Glass cover
Using the fan
The fan is located in the middle of the hob with the extractor facing
downwards.
Remove the glass cover before initial operation of the fan. The cover
does not need to be removed from models with an open aluminium
cover.
Important
Do not place the cover on the induction hob! Risk of burning!
The open aluminium cover does not
need to be removed.
Switching the fan on and off
Hint
In order to ensure that extraction functions well with tall cooking
pots (e.g. pots used for cooking asparagus), you can place a
wooden spoon under the lid of the pot.
Fan time lag
The fan time lag is used after cooker in order to remove cooking
odours. The filter is also dried in the fan.
Setting the fan time lag
The fan setting can be freely adjusted or changed when the fan time
lag is switched on.
Stop delay time
The fan motor should continue operating for another 10-10 minutes
every time the hob has been used for cooking.
This guarantees optimal functioning and the removal of remaining
cooking steam.
When using a recirculating air filter, please always allow for a stop
delay time of 10 - 60 minutes in order to optimally remove cooking
odours.
When the fan is switched on again, in rare cases the odour molecules
present in the filter may be combined with steam so that they are
detected again. These remaining odours will disappear when the fan
continues to operate.
Important
When the convection air mode is in operation, ventilation must be
sufficient in order for the air humidity to be removed.
1.
Press the standby key
(approx 1 sec.), until the appliance
switches into the standby mode.
2.
Press the fan Plus key
.
You will then be able to select a power setting, 1,2,3 or 4, by
using the Plus
/ or Minus key
light up. The intensive power setting 4 operates for 10 minutes,
after which the power level is automatically reduced to power
setting 3.
3.
Press the fan Minus key
until 0 is shown in order to switch
fan off.
1.
Press the fan Plus
and Minus keys
fan time lag of 10 minutes will be activated. The symbol for the
fan time lag will light up
..
2.
Pressing the Plus
and Minus keys simultaneously again
will set 60 minutes.
3.
The time lag function is deactivated by pressing the two keys
simultaneously again.
GB
. The symbol for the fan will
simultaneously. The
35
Publicité
