Philips HX9992/11 Mode D'emploi page 12

2
1
3
4
6
5
Brushing modes
Note: The bristles should slightly flare. Do not
scrub. A change in vibration from the handle and
the brushing feedback light flashes purple to alert
you when you apply too much pressure.
Gently move the brush head slowly across the
teeth in a small back and forth motion so the
longer bristles reach between your teeth. Continue
this motion throughout the brushing cycle.
6 To clean the inside surfaces of the front teeth, tilt
the brush handle semi-upright and make several
vertical overlapping brushing strokes on each
tooth.
7 The BrushPacer divides the brushing time into six
equal segments and indicates when you should
move to the next area. Segments are indicated
with a brief pause in vibration. The toothbrush
automatically stops at the end of the brushing
session.
Note: Your Philips Sonicare toothbrush is safe to use
on braces, dental modifications and dental
restorations (fillings, crowns, veneers)
Your power toothbrush comes pre-set to the all-in-
one clean mode that provides the dentist
recommended 2 minute brushing routine, with a six
segment brush pacer.
To personalize your brushing mode you can
customize your power toothbrush settings from the
Sonicare app (see 'Sonicare App - Getting Started').
Note: Although a mode is not displayed on the
toothbrush handle, you can update the mode any
time from the Sonicare App and your selection will be
stored.
13
English