Publicité
Les langues disponibles
Les langues disponibles
The duration of the Boost function depends on the selected heat setting of the corresponding cooking zone.
Setting + Boost
Boost function automatically shuts off after
Setting 1 + P
Setting 2 + P
Setting 3 + P
Setting 4 + P
Setting 5 + P
SWITCHING A COOKING ZONE OFF
Select the cooking zone you want to switch off by pressing the corresponding key. Touch the - key to decrease the heat
setting to [0]. By pressing the keys + and - simultaneously, the setting turns directly to [0].
If the cooking zone is hot, the displays shows an [H] instead of [0].
POWER MANAGEMENT
Thanks to the power management function, the user can set the maximum power of the hob if needed and power limit is
never exceeded.
How it works
If total power exceeds the adjusted limit, the power management function decreases the last selected hob zone power limit
automatically, then the display flashs and buzzer signal sounds. The power level of other cooking zones remain the same.
After energizing the hob, default power limit (32A) occurs on the display for 4-5 seconds as shown figure A.
A.
4 different power limits are available (13A,15A,16A,32A).
Power limit
13 A
15 A
16 A
32 A
Setting the power limit;
IMPORTANT: If another power limit is chosen than the default power limit, electrical network (cable, plug,fuse, etc.) must be
checked and changed if needed by a qualified technician according to local regulations.
After energizing the hob, in the first 60 seconds it is possible to set the required power limit by following steps:
1. First you will see the default setting on the display. (Figure A)
2. After this disappear turn on the hob by on/off key
3. Touch the 'A' and 'B' keys
4. Select the power limit by pressing the '+' or '-' buttons.
5. Then press 'A' and 'B' buttons at the same time for 2-3 seconds to set the selected limit. Now the hob is ready to use with
new power limit setting.
A
This setting is possible at any time and is maintained until the next change
1 minute
2 minutes
3 minutes
4 minutes
5 minutes
Required cable size
min. 3G1,5mm
2
min. 3G1,5mm
2
min. 3G1,5mm
2
min. 3G2,5mm
2
at the same time for 2-3 seconds. Then default power limit will appear again.
B
Setting + Boost
Setting 6 + P
Setting 7 + P
Setting 8 + P
Setting 9 + P
-
Power
2900 watt
3500 watt
3600 watt
7400 watt
.
Boost function automatically shut off after
6 minutes
7 minutes
8 minutes
9 minutes
-
English
25
•
Publicité
