FreshVAC VF 200 Mode D'emploi page 33

4 Vacuum& Seal (Vakuum & schweißen)
Draws air out of the bag and automatically changes operation to seal the bag after vacuum
is completed
5 Stop (Stopp): To cancel each vacuum or sealing process.
16.2 Appliance diagram
A Locking hook
B Vacuum chamber: Position the open end of the bag inside the chamber.
C1 Lower gasket + C2 Upper gasket (do not remove)
D Sealing profile: Presses the bag tightly against the sealing bar (E).
E Sealing bar:
seal but not to stick to the strip.
► Do not remove the Teflon tape.
WARNING
Please observe the following safety notice to reduce the risk of burns.
► Never touch the sealing bar while the unit is operating.
Contains a heating wire covered with teflon which allows the bag to
Please note
33