Suntec Wellness KLIMATRONIC MOVE 7.000 Eco R290 Manuel D'instructions page 18

Troubleshooting
Problem
1. Unit does not start
when pressing
"POWER".
2. It's not cool
enough.
3. Unit is too loud.
4. E2 Code
5. E1 Code
6. Compressor does
not start
Spare parts and accessories supply (fast convenient supply)
You can obtain spare parts and accessories for your MOVE unit from your local dealer. And at our
website
you will find further information on individual accessory products as well as information on obtaining
our spare parts quickly and conveniently. You will also find other information (e.g. FAQ, lists of spare
parts, document download, etc) on your MOVE unit.
Name EAN
Air-Block Klima-Sail
450 XXL 4250058312099
Possible causes
Water tank is full and Waterfull indicator
is illuminated.
Room temperature is lower than the set
temperature during operation mode
cooling.
The ambient temperature is too low or
too high.
In dehumidification mode, the ambient
temperature is too low.
Doors or windows are not closed.
There are heat sources in the room.
Exhaust hose is not installed or blocked.
Set temperature is too high.
Air inlet is blocked.
The ground is not even and flat enough
The sound comes from the flowing of
the refrigerant inside the unit.
Room temperature sensor is not
functioning.
The hose temperature sensor doesn't
work.
Thermal protection function is activated.
www.suntec-wellness.de
Description
Sail which can be used
for all types of windows and
doors. As for an external fly
screen, it is fixed with
Velcro and operated via a
zip. The window or door
can be closed at any time.
Suggestions
Empty the water tank.
Reset the temperature.
We recommend the operaiton at 17-35°C.
The ambient temperature needs to be
higher than 17°C.
Close all doors and windows.
Remove the heat sources if possible.
Install the exhaust hose and make sure
that the hose is clean and not blocked by
any objects.
Reset the temperature.
Clean the air inlet
Place the unit on an even and flat surface.
None, this sound is normal.
Let the sensor be replaced.
Let the sensor be replaced.
Please turn off the device and restart it 3
minutes later.
Drawing