IKRA ITHS 500 Manuel D'utilisation page 27

Remove transport protection
Before starting with the installation as described in the
operating instructions, please carry out the following
steps:
1. Pull the inner telescopic tube approx. 5 cm out of the
outer sleeve.
2. Then remove the rubber stopper. This is only required
as transport protection for the cable.
ca. 5 cm
2
Assembly
1. Rotate the knob (14) of the telescopic tube anticlock-
1
2. Rotate the knob (14) of the head tube clockwise ( )
GB-10
wise ( ) to loosen the tube.
14
to tighten the head part.
14