Quick Start - Vox JamVOX Guide D'installation Et De Configuration

In this section we'll explain the basics of using JamVOX by taking you through the actual
steps of operation.
Step1 Listen to the sound of the guitar programs
Guitar program
name
Effect routing
Amp/Cabinet
control panel
Effect Ctontrol
panel
1
Click the Program Select buttons (/) located at the right of the Guitar program name.
Clicking these buttons will move up or down through the programs one by one. Play
your guitar to try out each program.
HINT You can also use other ways to select programs. In the Help menu, click "Owner's
Manual..." to view the JamVOX Owner's manual, and refer to the section "Selecting
programs."
2
Click the Amp/Cabinet name displayed above the Effect rout‐
ing section.
In the Amp/Cabinet catalog that appears, you can change the
amp/cabinet.
HINT You can also change the effect units in the same way.
3
Try dragging and dropping an effect device to the location
where you want to connect it.
You are free to change the connected order of all of the effect
units.
HINT The amp/cabinet and effect units can be adjusted in their corresponding control
panel. The Effect control panel is shown for the effect device you select by clicking.

Quick Start

Program Select buttons
En-9