Publicité
Les langues disponibles
Les langues disponibles
Faucet Installation
Parts List for Faucet
Item Description
A
Escutcheon Plate
B
Black Rubber Washer
C
Black Locating Washer (use where A 1/2" hole
is available, reverse when mounting on stain-
less steel or when using drilled hole)
D
Lock Washer
E
Nut
F
Insert
G
Plastic Sleeve
H
1/4" Compression Nut
Gather and identify the faucet pieces
Step 5:
Place the escutcheon plate and the black rubber washer on the threaded stem. (Parts found in faucet
parts bag).
Step 6:
Insert the threaded stem through the hole in sink and let it rest on the sink top.
Step 7:
From the underside of the sink, slide on the black locating washer, lock washer, and nut onto the
threaded stem. Check the orientation of faucet then tighten the nut securely
Step 8:
Locate the 1/4" blue that is attached to the right side of the filter system. Grab the following parts from
the faucet parts bag and place onto the end of the tube: the brass nut, plastic sleeve (small tapered end
of sleeve must point to the end of tube), and then insert the plastic insert all the way into the end of the
tube.
Step 9:
Push the assembled tube into the threaded stem until it stops. Slide the compression nut and plastic
sleeve until you can thread the nut onto the faucet. Use a wrench to securely tighten the compression
nut while continuing to push the tube into the faucet.
A
B
C
E
G
H
Page 9
D
F
Publicité
