Publicité
Les langues disponibles
Les langues disponibles
Adapt-a-Valve Installation
Water supply line to the system must be from the cold water supply line only. Hot water will
NOTICE
severely damage your system.
Do not use Teflon tape with the Adapt-A-Valve™.
NOTICE
Parts List for Adapt-A-Valve
Item Description
A
Brass Adapter with black washer
B
Plastic Adapt-A-Valve & black collet
C
White Rubber Washer
D
Brass Adapter with no washer
Step 10:
Turn off the cold water supply to the faucet by turning the angle stop valve completely off.
Step 11:
Open cold water sink faucet to relieve pressure.
Step 12:
Choosing the configuration that fits your plumbing, attach the Adapt-A-Valve™ as illustrated in the
diagrams above.
Make sure that the black collet is installed in to the 1/4" opening on the Adapt-a-valve. Don't
NOTICE
forget to install the white compression washer with the 3/8" configuration. The Brass Adapters
do not need to be tightened with a wrench, only finger tight.
Green Tube Connection
Step 13:
Locate the 1/4" green tube attached to the left side of the filter system
and insert into the 1/4" quick connect fitting on the plastic Adapt-A-
Valve. Make sure to push the tube all the way to the tube stop.
Faucet Line
Faucet Line
A
A
B
B
C
D
C
D
Cold
Water
Supply
Cold
Water
Supply
For 3/8" Configuration
Page 10
Faucet
Connection
Faucet
Connection
B
B
Line from
Cold Water
Supply
Line from
Cold Water
Supply
For 1/2" Configuration
Publicité
