Publicité
Page 2 of 5
TOOLS REQUIRED
Set of metric Allen keys to include
•
•
•
ITEM NO.
ITEM 1
ITEM 2
ITEM 3
ITEM 4
Please make sure the engine is cold before proceeding with the fitting of the R&G cover.
•
To fit the R&G engine case cover remove the 4x M6 engine case bolts in the positions arrowed
•
above using a T30 Torx tool. Hold the cover loosely over the case to help identify the correct
ones.
Offer up the R&G cover to the engine and carefully fit it over the casing.
•
Ensure that the 4x R&G bolts are lined up with the holes in the engine casing, and then push on
•
as far as it will go.
•
Fit the 50mm bolt into the location circled in green on the front page.
Fit the 45mm bolts into the locations circled in yellow on the front page.
•
•
Fit the 40mm bolt into the location circled in orange on the front page.
With a 5mm Allen key tighten the bolts equally so that they pull the cover into place. DO NOT
•
FULLY TIGHTEN.
Finally use a torque wrench set at 10 N/m (7 Lb/ft) to fully tighten.
•
It is suggested that you check the tightness of the mounting bolts on a regular basis i.e. when
•
cleaning or once a month.
NOTE for the cleaning of this product you should only use a soft polishing cloth and a mild
•
general cleaning agent.
AVOID HARMFUL CHEMICALS. IF IN DOUBT DO NOT USE AS THEY COULD ALTER THE
•
STRENGTH OF THE COVER.
R&G will accept no liability if the above procedure and torque settings are not followed.
•
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
5mm A/F.
8mm Socket and Wrench.
Suitable Torque Wrench.
R&G ENGINE CASE COVER WITH SPACERS FITTED (ECC0389)
M6 x 40mm LONG CAP HEAD BOLT
M6 x 45mm LONG CAP HEAD BOLTS
M6 x 50mm LONG CAP HEAD BOLT
FITTING INSTRUCTIONS
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
GENERAL TORQUE SETTINGS
M5 BOLT =
M6 BOLT =
M8 BOLT = 20Nm
M
M12 BOLT = 40Nm
LEGEND
DESCRIPTION
R&G
www.rg-racing.com
ECC0389
M4 BOLT = 8Nm
2Nm
1
5Nm
1
0 BOLT = 40Nm
1
Email:
info@rg-racing.com
QTY
1
1
2
1
Publicité
