Publicité
Les langues disponibles
Les langues disponibles
Drain water
1) Special reminder: There is condensing water recycling hidden in this appliance. The condensing water is
partly kept recycling between the condenser and the water tray. When the water level rises to the upper
level, the water-full code "E4" will be shown on the digital display to remind of draining water.
2) Please cut off the power supply, move the appliance to a suitable place, pull out the stopper in the drain
port to drain the water completely. If conditions permitted, you can also connect the drain hose to the
drain port for the water draining.
3) After the draining, insert back the stopper to the drain port, otherwise the appliance may leak and make
your room wet.
CLEANING AND MAINTENANCE
Before cleaning, be sure to disconnect the appliance from any electric supply outlet.
Do not use gasoline or other chemicals to clean the appliance.
Do not wash the appliance directly.
If the appliance is damaged, please contact the dealer or repair shop.
Air Filter
If the air filters become clogged with dust/dirt, they should be cleaned once every
two weeks.
-
Pull out the air filters by the pull tab.
-
Clean the air filters with neutral detergent in lukewarm water (< 40℃) and dry
it up in the shade.
-
Reinstall the air filter.
Clean the Surface
First clean the surface with a neutral detergent and wet cloth, and then wipe it with a dry cloth.
TROUBLESHOOTING
The following cases may not always be a malfunction, please check suggestions below before asking for service.
Touble
Does not run
Runs for a short while only
Water leak during moving
The appliance does not run and
water-full code "E4" appears on
the display
Appliance automatically stops
Analysis
If the protector trip or fuse is blown.
Please wait for 3 minutes and start again, protector device may be
preventing unit from working.
If batteries in the remote controller are exhausted.
If the plug is not properly plugged in.
If the set temperature is close to room temperature, you can lower
the set temperature.
Air outlet is blocked by obstacle. Take the obstacle away.
Drain the condensate before moving.
To avoid water leakage, please locate the unit on flat ground.
Pull out the rubber plug to drain water.
If it is often in this state, please contact qualified service technical.
Timing shut down
Set temperature reached
- 7 -
Publicité
