biohort StoreMax 190 Notice De Montage page 9

2.
M M o o u u n n t t i i n n g g t t h h e e s s i i d d e e w w a a l l l l s s : :
Insert the right wall into the U-profile of the right side of
the base plate. (Attention: you can recognise the right
wall by the fact that the roller shutter brake spring is
positioned at the front - see photo on page 10).
Connect the right wall to the back wall provisionally (as
shown in photo on page 10) with the black plastic part
(assembly aid, which will later serve as a spacer for the
base plate/ back wall). Do not rely solely on the assembly
aid to hold the back and side walls together.
Now screw the right wall to the base plate with 2 short
stainless steel sheet metal screws. In the same way,
place the left wall in the U-profile of the left side of the
base plate.
Again, secure this side wall with the black assembly aid
as shown. Also screw the left wall to the base plate with 2
short stainless steel sheet metal screws. Now screw the
aluminium profiles of the left and right walls at the front to
the base plate with the long stainless steel screws.
IMPORTANT: SHARP EDGES! USE WORK GLOVES TO PREVENT INJURY!
Importante: ¡Cantos afilados! Utilice guantes de trabajo para evitar lesiones.
ES
Important : bords tranchants ! Utilisez des gants de travail pour éviter toute blessure !
FR
R
Front side
antèrieur
R
Back side
l'envers
7
9