Samsung WF433B GJ Serie Manuel D'utilisation page 35

Les langues disponibles

PURE CYCLE

Pure Cycle is a self-cleaning cycle that removes mold that may occur inside the washing machine.

1. Press the Power button.

2. Press the Pure Cycle

•

3. Press the Start/Pause button.

•

Using Pure Cycle, you can clean the drum without using a cleansing agent.

•

Never use Pure Cycle when laundry is in the washing machine. This may cause damage to

CAUTION

the laundry or a problem with the washing machine.

•

If you want to use drum cleansing agent, use only 1/10 of the amount of the drum

cleansing agent recommended by the cleansing agent manufacturer. (When using a

powder-type cleansing agent , remove the liquid detergent compartment.)

The Pure Cycle Auto Indicator Function

•

If the "Pure Cycle" button is lit after a wash, it indicates

that tub (drum) cleaning is required. In this case, remove

the laundry from the washing machine, turn the power on,

and clean the drum by running Pure Cycle.

•

If you do not run Pure Cycle, the "Pure Cycle" indicator

turns off. However, the "Pure Cycle" indicator will light

again after two washes. Not running Pure Cycle at this

point will not cause a problem with the washing machine.

•

Although the Pure Cycle Auto Indicator appears once a

month or so, the frequency may differ depending on the

number of times the washing machine is used.

WF433BGJ-03159C-02_EN_20120829.indd Sec4:35

button.

Once the Pure Cycle button is pressed, the only

function that can be set is Delay Start.

If you press the Start/Pause button, Pure Cycle

begins.

maintaining your washer _35

2012-08-31

12:35:32