Samsung WF433B GJ Serie Manuel D'utilisation page 20

Les langues disponibles

installing your washer

5. Slide your washer into position.

6. Level your washer by turning the leveling legs in or out as

necessary by hand or by using the wrench included with

your washer.

When your washer is level, tighten the locking nuts using

the wrench or (-) flathead screwdriver.

7. Plug the power cord into a 3-Prong, well grounded 120

volt 60 Hz approved electrical outlet protected by a 15-

amp fuse or comparable circuit breaker.

Your washer is grounded through the third prong of the

power cord when plugged into a three-prong grounded

receptacle.

Your Washer must be leveled on all four sides. A

carpenter's level should be used on all four corners of

your Washer. It's a good idea after the first dozen washes

to recheck your washer's levelness.

Avoid damage to the legs. Do not move

the Washer unless the Locking-nuts are

fastened to the bottom of the Washer.

STEP 4

Calibration mode

Before using Calibration mode, be sure to take out all items from the drum.

Your Samsung washer automatically detects the weight of the laundry.

For more accurate weight detection, please run Calibration Mode after the installation.

Calibration mode is performed by following the steps below.

1. Turn on the washer.

2. Press the Temp. button and Delay Start button simultaneously at least 3 seconds.

3. Remove any contents in the tub and close the door.

4. Press the Start/Pause button to run Calibration Mode.

5. The drum rotates clockwise and counterclockwise approximately for for approximately 3

minutes.

6. When Calibration Mode is finished, the "En/End" appears on the display and the washing

machine turns off automatically. The washing machine is now ready for use.

20_ installing your washer

WF433BGJ-03159C-02_EN_20120829.indd Sec3:20

Locking

Nut

Levelling

Leg

2012-08-31

12:35:29