Simons Voss Technologies Digital SmartHandle AX Stationary installation Guide Abrégé page 51

Digital SmartHandle AX Stationary installation
17. Fasten the set screw on the inner handle firmly
(TX15, torque 5.0 Nm).
41
18. For FH: insert the dummy cylinder.
NOTE
Feed the blank cylinder into the hole using a screw-
driver
It is difficult to position the blank cylinder correctly, es-
pecially in thick doors.
1. Insert a screwdriver into the hole in the blank cylin-
der.
2. Position the blank cylinder using the screwdriver.
42
43
19. For FH: screw the dummy cylinder firmly into place
(PH2, torque 1.1 Nm).
44
20. Place the two cover plates with the notch facing
downwards onto the escutcheon base and the in-
ner handle.
45
21. On the outside, place the cover with the notch fa-
cing downwards onto the escutcheon base.
46
22. Fit the outside handle into position on the fitting.
47
23. Firmly fasten the grub screw on the outside handle
(TX15; torque: 5.0 Nm).
48
9 Fitting is now installed.
10. Removing the fitting
1.5 mm hexagonal wrench available.
ü
1. Remove the fitting in the reverse order to installa-
tion.
2. Insert a 1.5 mm hex key into the hole in the spindle
mount in the fitting.
49
3. Bend the hex key to the side where the hole is loc-
ated while pulling on the outside handle.
50
EN
9 Fitting is now removed.
11. Replacing the batteries
NOTE
Malfunctions due to poor contact or different dis-
charge
Contact surfaces that are too small/contaminated or
different discharged batteries can lead to malfunc-
tions.
1. Only use batteries that are approved by
SimonsVoss.
2. Do not touch the contacts of the new batteries
with your hands.
3. Use clean and grease-free gloves.
4. Always replace all batteries at the same time.
ü Special tool at hand.
ü Gloves at hand.
1. Insert the special tool into the fitting's cover inlay.
51
2. Remove the cover with the tool.
52
53
3. Carefully bend the battery clip inwards to detach it.
54
55
4. Open the battery holder.
56
5. Remove the battery holder.
57
6. Remove the old batteries.
58
7. Insert the new batteries with the positive terminals
next to each other (type CR2450).
59
8. Put the battery holder back into place.
60
9. Reattach the battery clip.
61
10. Replace the cover on the fitting.
62
10. Removing the fitting
51 / 92