Simons Voss Technologies Digital SmartHandle AX Stationary installation Guide Abrégé page 50

8. Programming the fitting
3. For X: mark the sawing points on the threaded rods
and spindle.
13
14
15
4. For X: use a suitable saw to cut the threaded rods
and spindle.
16
8. Programming the fitting
Programme the fitting before installation. You can use
different programming devices, depending on the
product family.
17
18
19
9. Installing the fitting
Door pre-drilled.
ü
PH2 screwdriver at hand.
ü
TX15 screwdriver at hand.
ü
Vernier calliper at hand.
ü
Pincers at hand.
ü
1. For S, M and L: measure the door thickness.
20
2. For S, M and L: determine the separation points on
the cut-to-length screws L1 and L2.
21
22
3. For S, M and L: trim the cut-to-length screws L1 and
L2.
23
4. For 7 mm spindle: place the adapter sleeve in the
inner handle in such a way that the recess faces the
grub screw.
24
5. Determine your inner handle's direction rotation as
viewed from the inside: clockwise (clockwise =
CW) or anti-clockwise (counter-clockwise = CCW).
25
26
6. Insert the interchangeable plate into the inner
handle as required.
27
50 / 92
Digital SmartHandle AX Stationary installation
28
7. Press the spring plate on one side against the inter-
changeable plate so that the spring is compressed.
29
8. At the same time, hook the spring plate tabs into
the slot in the inner handle.
30
9. Press down the spring plate bracket.
31
9 The inner handle is now ready.
32
10. For 7 mm spindle: insert the adapter sleeve onto
the side of the spindle with the pin.
33
11. Insert the spindle with the pin side into the fitting.
9 Pin will snap into position in the mount.
34
35
12. For 8.5 mm and 10 mm spindle: slide the adapter
sleeve into the centre of the spindle. Use a punch
and hammer to make an indent in the adapter
sleeve to prevent it from slipping.
36
37
13. Insert the fitting with the spindle into the door. Use
adapter sleeves if necessary.
38
Ø mortise lock fastening
hole
5.5 mm–6.3 mm
6.4 mm–7.3 mm
7.4 mm–8.7 mm
≥ 8.8 mm
14. Insert the escutcheon base into the door with the
sleeve nuts.
15. Fasten both escutcheon bases together with the L2
screws (PH2, torque 1.1 Nm).
39
16. Fasten the inner handle firmly with the L1 screws
(PH2, torque 1.1 Nm).
40
Adapter sleeves
No adapter sleeves
6.4 mm
7.4 mm
8.8 mm
EN