Simons Voss Technologies Digital SmartHandle AX Scandinavian Oval Guide Abrégé page 40

3. Product-specific safety instructions
Damage due to polarity reversal
This product contains electronic components that
may be damaged by reverse polarity of the power
source.
Do not reverse the polarity of the voltage source

(batteries or mains adapters).
Operational malfunction due to radio interference
This product may be affected by electromagnetic or
magnetic interference.
Do not mount or place the product directly next to

devices that could cause electromagnetic or mag-
netic interference (switching power supplies!).
Communication interference due to metallic sur-
faces
This product communicates wirelessly. Metallic sur-
faces can greatly reduce the range of the product.
Do not mount or place the product on or near

metallic surfaces.
NOTE
Intended use
SimonsVoss-products are designed exclusively for
opening and closing doors and similar objects.
Do not use SimonsVoss products for any other pur-

poses.
Malfunctions due to poor contact or different dis-
charge
Contact surfaces that are too small/contaminated or
different discharged batteries can lead to malfunc-
tions.
1. Only use batteries that are approved by
SimonsVoss.
2. Do not touch the contacts of the new batteries
with your hands.
3. Use clean and grease-free gloves.
4. Always replace all batteries at the same time.
Different times for G2 locks
The internal time unit of the G2 locks has a technical
tolerance of up to ± 15 minutes per year.
Qualifications required
The installation and commissioning requires special-
ized knowledge.
Only trained personnel may install and commission

the product.
40 / 80
Digital SmartHandle AX Scandinavian Oval
Modifications or further technical developments can-
not be excluded and may be implemented without no-
tice.
The German language version is the original instruction
manual. Other languages (drafting in the contract lan-
guage) are translations of the original instructions.
Read and follow all installation, installation, and com-
missioning instructions. Pass these instructions and
any maintenance instructions to the user.
3. Product-specific safety in-
structions
IMPORTANT
Damage caused by unsuitable tools
If you try to open the case with unsuitable tools, the
case may be damaged.
Use only the supplied SimonsVoss opening tool.

Loss of the precise guidance of the handle
It may be difficult to install on mortise locks with a re-
taining nut.
Do not mechanically alter the locking nut. The

handle would then lose its precise guidance.
NOTE
Effect on the mortise lock
The SmartHandle AX acts exclusively on the latch of
the mortise lock.
Locking and insurances
Insurance companies place increased demands on a
closure.
1. If you want to lock the door under insurance law,
use a self-locking panic lock or a locking cylinder in
addition to the SmartHandle AX.
2. Pay attention to the approvals according to EN 179.
SmartHandle AX with self-locking panic lock
The SmartHandle AX only offers full functionality with
a self-locking panic lock.
1. Combine the SmartHandle AX with a self-locking
panic lock.
2. Pay attention to the declarations of conformity of
the lock manufacturers according to EN 179.
EN