Franke FMA 605 WH FRK Mode D'emploi Et Installation page 8

Fitting the hood body
• Open the doors/the door (See section Open Panels).
• Remove the Metal grease filters using the handles
provided.
• Adjust the two screws Vr, in the brackets 11a, so that
they are at the start of their travel.
• Hook the hood body to the two brackets 11a.
• From the inside of the hood body, turn screws Vr to
level the hood body itself.
• Fasten the safety screw 12a.
• Close the doors/the door again.
DUCTED VERSION AIR EXHAUST SYSTEM
When installing the ducted version, connect the hood to
the chimney using either a flexible or rigid pipe ø 150 or
120 mm, the choice of which is left to the installer.
• To install a ø 120 mm air exhaust connection, insert the
reducer flange 9 on the hood body outlet.
• Fix the pipe in position using sufficient pipe clamps
(not supplied).
• Remove any activated charcoal filters.
RECIRCULATION VERSION AIR OUTLET
• Insert the connection extension pieces laterally 14.1 in
connection 15.
• Insert the Connector 15 into the Support bracket 7.3 and
fix it with 2 screws.
• Make sure that the outlet of the extension pieces 14.1 is
horizontally and vertically aligned with the chimney
outlets.
• Connect the air outlet connection 15 to the hood body
outlet using either a flexible or rigid pipe ø 150 mm,
the choice of which is left to the installer.
• Ensure that the activated charcoal filters have been in-
serted.
EN
Connections
11a
Vr
12a
ø 120
ø 150
9
8
8