5.
If the electrical cable is damaged, it must be replaced by the manufacturer, their
service department or somebody with similar qualifications in order to prevent
creating a hazard.
Failing to adhere to points 3, 4, 5, could lead to damage, fire and/or personal injury. They
will invalidate the guarantee and the supplier, importer and/or manufacturer shall not be
liable for the consequences.
Description
1. Control dial
2. Thermostat dial
3. Handle
4. Air outlet grill
5. Air intake grill
Location and connection
Remove all packaging material and keep out of reach of children. After removing
packaging, check the appliance for damage or other signs that could indicate a
fault/defect/malfunction. In case of doubt, do not use the appliance, but contact your
vendor for inspection or replacement.
Select a suitable location for the device taking into account all the
aforementioned warnings in this manual.
Check if the control switch is set to 'OFF' (O).
Fully extend the power cord and plug into a suitable 220-240 V socket. To prevent the
circuit overloading, check that no other appliances are connected to the same group.
Set-up and operation
Turn the thermostat dial to maximum (clockwise as far as possible).
Switch the heater on by turning the control dial to one of the following three positions:
800W, 1600W or 2400W. It is most economical to heat the space at full power, then to
switch to a lower power to maintain the temperature.
At all powers, the fan rotates at the same speed; the difference lies in the number of
heating elements in use.
Once the desired temperature is reached, turn the thermostat dial back slowly until
you hear a click. The temperature is now set. The heater will automatically switch on
and off to maintain the set temperature. To set a higher or lower temperature, turn
the thermostat dial either clockwise or anticlockwise.
To switch the heater off, set the control dial to '0' (off). Unplug.
24