Transportation - Positioning - Installation; Starting Up - Inomak UBD2000 Manuel D'installation, D'utilisation Et D'entretien

ENGLISH
2. Transportation – Positioning – Installation
!
Keep the appliance in an upright position during the transportation in order
to avoid critical damage in its systems.
Remove all packaging. Move carefully the device to its final position. If the floor is not flat, adjust the legs
so the front side is approximately 1cm higher from the back to ensure that the doors are closing.
To ensure efficient operation do not place it near heat sources. The appliance
!
is designed to operate in an ambient temperature of up to 40 °C.
Remove the power cord from the interior of the appliance. Power must be connected via a wall socket. The
appliance is supplied with an electric plug.
!
Current taps and plugs must always be provided with ground.
If the device has a showcase remove the small wrapping cartons underneath the crystals and carefully move
the side glasses unscrewing the screws pointed at the graph, so that they line-up with the front crystal of the
show case.

3. Starting up

Press the on/off switch. The figure that appears in the display shows the actual temperature in the
cabinet and indicates that power is connected. The motor starts after 2 minutes.
!
Do not store products in the appliance until its temperature reaches at the required
point. Do not fill at once your appliance with big quantities of products.
3