MAXXMEE CBL-SV1606 Mode D'emploi page 21

Cordless Handheld & Floor Vacuum Cleaner
4. Tap out both filters and clean them
with a soft brush if necessary. They
can also be rinsed out with clear wa-
ter, but they must be completely dry
before they are assembled!
5. Wipe the dust container with a damp
cloth if necessary and then dry it or
allow it to dry in the air. Never as-
semble wet or damp components or
attach them to the motor unit (3)!
6. When all components are dry, insert
the EPA8 filter into the metal filter and
twist it anticlockwise to secure it.
7. Insert the metal filter into the dust
container and twist it anticlockwise to
secure it.
8. Close the dust container.
Cleaning the Exhaust Air Filter
1. Press the release button (24) to open
the filter compartment cover (23).
2. Pull the exhaust air filter out of the
exhaust air filter compartment (22).
3. Tap out and brush out the exhaust air
filter and the exhaust air filter com-
partment. The exhaust air filter can
also be rinsed out with clear water,
but it must be completely dry be-
fore it is assembled!
4. Insert the cleaned exhaust air filter
into the exhaust air filter compartment
and flip the filter compartment cover
shut.
Cleaning the Motor Unit, Extension
Tube and Nozzles
• Wipe down the motor unit (3), the
extension tube (5) and the nozzles (1,
7, 8) with a damp cloth if necessary.
Then wipe them dry.
• Remove hair and fluff from the nozzles
and brushes.
02026_Inlay_de-en-fr-nl_A5_V1.indb 19 02026_Inlay_de-en-fr-nl_A5_V1.indb 19
Cleaning the Floor Nozzle
To make it easier to clean, the brush can
be removed from the floor nozzle (7):
1. Turn over the floor nozzle so that the
bottom is pointing upwards.
2. On the right side there is a catch next
to the small wheel. Slide the catch
outwards.
3. Take out the brush and remove any
dirt and contamination.
4. Reinsert the brush. When you do this,
insert the end with the star-shaped
recess first. Then press the other end
into the holder until it engages.
5. Slide back the catch.
Storage
• Store the device and accessories in
a cool, dry place which is protected
from direct sunlight and is out of the
reach of children and animals.
• The 2 in 1 upholstery and brush noz-
zle (1) and crevice nozzle (8) can be
plugged onto the nozzle holder (6) on
the extension tube (5) (Picture E).
• Hang the motor unit (3) with the suc-
tion opening (21) facing downwards
into the wall mounting bracket (4).
The button for opening the dust con-
tainer flap (19) must rest in the hollow
of the wall mounting bracket.
L
To prevent a deep discharge of
the battery, charge it up every
3 months if it is not used for a
prolonged period.
EN
19
14.10.2020 14:39:56 14.10.2020 14:39:56