Wall Mounting Bracket; Charging Up The Battery - MAXXMEE CBL-SV1606 Mode D'emploi

Cordless Handheld & Floor Vacuum Cleaner
WALL MOUNTING
BRACKET
Please Note!
■
Make sure that the surface on which
the wall mounting bracket is mounted
is stable and that screws and anchors
which are suitable for the wall are
used. Seek advice from a specialist
retailer if in doubt.
■
Before drilling, ensure that there are
no pipes or cables behind the intend-
ed drilling point.
The device can be stored in the wall
mounting bracket (4) and charged up
there for its next use (Picture E).
The wall mounting bracket can be affixed
or screwed onto the wall. The items
supplied include 2 screws and anchors to
allow you to do this.
L
Ideally attach the wall mounting
bracket near to an easily accessi-
ble plug socket so that the device
can be charged.
The cord of the connecting
cable (2) can be tucked in on the
small hook on the wall mounting
bracket.
Sticking On the Wall Mounting
Bracket
Make sure that the spot on which the wall
mounting bracket is to be stuck is clean,
dry and free of dust.
1. Peel off the protective strips from the
adhesive pads on the back of the wall
brackets.
2. Stick the wall mounting bracket
straight onto the wall and press it on
firmly.
02026_Inlay_de-en-fr-nl_A5_V1.indb 17 02026_Inlay_de-en-fr-nl_A5_V1.indb 17
Screwing On the Wall Mounting
Bracket
1. Place the wall mounting bracket
straight against the wall and mark out
two drill holes.
2. Drill holes into the wall and place
anchors in them.
3. Screw on the wall mounting bracket.
Inserting the Motor Unit
Insert the dust container (20) into the
wall mounting bracket so that the button
for opening the dust container flap (19)
rests in the hollow of the wall mounting
bracket.
CHARGING UP THE
BATTERY
Please Note!
■
Only connect the mains adapter to a
plug socket that is properly installed
and matches its technical data. The
plug socket must be readily accessible
after connection so that the con-
nection to the mains can quickly be
isolated.
■
Only use suitable extension cables
whose technical data is the same as
that of the mains adapter.
■
Pull the mains adapter out of the plug
socket if an error occurs during charg-
ing or before a thunderstorm.
■
It is essential that you charge up the
battery fully before you first use the
device in order to achieve the maxi-
mum charging capacity. If the battery
is fully discharged during use, it must
be fully charged up again before it is
next used.
1. Plug the barrel connector of the
connecting cable (2) into the charging
socket (14).
EN
17
14.10.2020 14:39:56 14.10.2020 14:39:56