VINCENT SV-238MK Manuel D'utilisation page 37

CONNECTION OF THE LOUDSPEAKERS
If you want to use speaker cables equipped with spade lug connectors, every connector screw must be opened
by turning counter clockwise. After that, the lug must be moved under the screw head. Then, turn the screw clock-
wise to fasten the lug to the connector. To avoid damages to the amplifier, make sure the connection is tight and
no bare metal from the cable lug connector makes contact with the rear panel or with another terminal.
If you intend to connect two pairs of speakers, all loudspeakers must have a nominal impedance
of at least 8 Ω. If only one pair of speakers is connected, all types of loudspeakers with a minimal
nominal impedance of 4 Ω can be used.
Consider correct polarity, the positive contact is mostly marked red or with "+". The side of the
speaker cable that has to be connected with the positive socket has a marking.
CONNECTION OF THE POWER CABLE
Check if the electricity supply of your home is appropriate to the device. The required voltage and fre-
quency can be read on the back of the device beside the socket for the mains. Keep in mind that this
amplifier may demand a short term value of the electrical power of up to 1000 W. That is why you should
use only appropriate extension cables and distribution boxes if that is not avoidable. Check if your home
power supply, the fuses and the amplifier power cable are qualified to be used with 16 A of electrical
current. If the electricity supply is appropriate, push the inlet connector of the supplied mains cable firmly
into socket for the mains on the back of the device (11). Connect the other end of the mains cable to a
mains socket.
Vincent
37