Télécharger Imprimer la page

Zanussi ZDF12001XA Notice D'utilisation page 14

Publicité

Les langues disponibles

Les langues disponibles

Problem and alarm code
The programme does not start.
The appliance does not fill with wa-
ter.
The indicator
intermittently.
The indicator
ously.
The appliance does not drain the
water.
The indicator
times intermittently.
The indicator
ously.
The anti-flood device is on.
The indicator
times intermittently.
The indicator
ously.
Once you have checked the appliance, press
the problem occurs again, contact the Service.
THE WASHING AND DRYING RESULTS ARE NOT SATISFACTORY
Problem
There are whitish streaks or blu-
ish layers on glasses and dishes.
There are stains and dry water
drops on glasses and dishes.
The dishes are wet.
Refer to "Hints and tips" for other
possible causes.
14
flashes 1 time
flashes continu-
flashes 2
flashes continu-
flashes 3
flashes continu-
The release quantity of rinse aid is too much. Adjust the rinse
aid selector to a lower position.
The quantity of detergent is too much.
The released quantity of rinse aid is not sufficient. Adjust the
rinse aid selector to a higher position.
The quality of the rinse aid can be the cause.
The programme does not have a drying phase or has a drying
phase with low temperature.
The rinse aid dispenser is empty.
The quality of the rinse aid can be the cause.
Possible solution
Make sure that the appliance door is closed.
Press Start.
The appliance has started the procedure to recharge the
resin inside the water softener. The duration of the proce-
dure is approximately 5 minutes.
Make sure that the water tap is open.
Make sure that the pressure of the water supply is not too
low. For this information, contact your local water authority.
Make sure that the water tap is not clogged.
Make sure that the filter in the inlet hose is not clogged.
Make sure that the inlet hose has no kinks or bends.
Make sure that the sink spigot is not clogged.
Make sure that the drain hose has no kinks or bends.
Close the water tap and contact the Service.
For alarm codes not described in the table, contact
. If
the Service.
Possible solution

Publicité

loading

Ce manuel est également adapté pour:

Zdf12001sa