Maintenance And Troubleshooting - Wine Cell'R WC-52BKTS Manuel De L'utilisateur

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

6
7. CAUTIONS
• When using wine cellar for the first time or after it has been moved, wait for
24 hours before plugging in to avoid damage to the compressor.
• After removing the power plug from the outlet, wait 5 minutes before plugging wine
cellar in again to avoid damage to the compressor.
• If there seems to be a temperature sensor failure, please reset the wine cellar: turn
it on for 5 minutes, turn it off for 20 minutes and turn it back on. Make sure the
wine cellar is plugged into an approved circuit or outlet. To prevent accidents, do
not use on an overloaded circuit or outlet. The electrical outlet should have proper
ground fault protection.
• Do not use this wine cellar if electrical supply outlet is questionable or does not
conform to these instructions. Use caution with the electrical cord to prevent
it from damage.
• Do not place weight on the electrical cord. Consumers should not attempt to use an
extension cord to connect power to the unit. Please contact a qualified electrician to
have the power cord replaced in accordance with applicable electrical codes.
• Remove all packing prior to using the wine cellar to ensure proper operation.
• Explosive containers or hazardous chemicals cannot be stored in the wine cellar
under any circumstances.
• Be careful not to pour water or other liquids on the wine cellar. Moisture on the
electrical wires or components could cause result in an electrical hazard, short
circuit or other malfunctions.
• Internal wine cellar temperature fluctuations are normal.
• Do not put excessive weight on the wine cellar or on its door. This might affect its
stability and make it topple over.

8. MAINTENANCE AND TROUBLESHOOTING

• If the wine cooler does not get cold at all: Check to ensure the power plug is
installed properly.
• When using wine cellar for the first time or after it has been moved, wait for
24 hours before plugging in to avoid damage to the compressor.
• If the wine cooler does not get cold enough: Is the temperature set too high? Is the
door being opened and closed too frequently? Has the interior light been on for
extended period?
• If the wine cooler seems to be noisy: make sure it is properly leveled and standing
up firmly. You may have to adjust the leveling legs. Also check to see if there may be
another source of noise nearby as this might be the noise source.
1. Porte en verre
2. Panneau de ventilation à l'avant
3. Pied de nivellement réglable
4. Étagère à vin
5. Cabinet
6. Panneau de contrôle
7. Indicateur de température LED
8. Boutons de réglage de la température
9. Bouton d'éclairage interne
10. Bouton de verrouillage

Publicité

Table des Matières
loading

Table des Matières