Brush Replacement - Rubi DT180EVO Manuel D'utilisation

MAINTENANCE

BRUSH REPLACEMENT

See Figure 29.
The saw has externally accessible brush assemblies that
should be periodically checked for wear.
Proceed as follows when replacement is required:
 Unplug the saw.
 Remove brush cap with a screwdriver. Brush assembly is
spring loaded and will pop out when you remove brush
cap.
 Remove brush assembly.
 Check for wear. Replace both brushes when either has
less than 1/4 in. length of carbon remaining. Do not
replace one side without replacing the other.
 Reassemble using new brush assemblies. Make sure
curvature of brush matches curvature of motor and that
brush moves freely in brush tube.
 Make sure brush cap is oriented correctly (straight) and
replace.
 Tighten brush cap securely. Do not overtighten.
CLEANING THE WATER NOZZLE
If the water nozzles become clogged with debris, they shouild
be removed and rinsed with clean water. The nozzles just
push on and pull off the connector on either side of the
cutting wheel.
BRUSH CAP
24 — English
BRUSH
ASSEMBLY
Fig. 29