Rubi DT180EVO Manuel D'utilisation page 14

ASSEMBLY
INSTALLING THE TILE CUTTING WHEEL
See Figure 11.
WARNING:
A 7 in. tile cutting wheel is the maximum wheel
capacity of the saw. Never use a wheel that is too
thick to allow wheel washer to engage with the
flats on the spindle. Larger wheels will come in
contact with the splash hood, while thicker wheels
will prevent the wheel bolt from securing the wheel
on the spindle. Either of these situations could
result in a serious accident and can cause serious
personal injury.
 Unplug the saw.
 Place the wheel wrench on the arbor nut then slide the
arbor wrench into the arbor.
 Holding the arbor wrench firmly to prevent movement,
pull the wheel wrench (left side) forward to the front of
the machine to loosen.
 Remove the arbor nut and outer washer leaving the inner
washer on the arbor.
WARNING:
Always install the inner wheel washer before plac-
ing wheel on arbor. Failure to do so could cause an
accident since the wheel will not tighten properly.
Never use wheels that have openings, grooves, or
teeth on this tool.
 Place the cutting wheel onto arbor with the arrows on
wheel going in the counterclockwise direction.
 Replace the outer washer. The double "D" flats on the
washers align with the flats on the arbor.
 Replace the arbor nut on the arbor. Using wheel wrench
and arbor wrench, tighten arbor nut securely.
NOTE: Two water nozzles come installed on this product.
The hole in each nozzle should face the cutting wheel.
WATER
NOZZLES
14 — English
ARBOR TILE CUTTING
WHEEL
INNER
WASHER
OUTER
WASHER
ARBOR
NUT
Fig. 11