Filling/Changing The Water Reservoir - Rubi DT180EVO Manuel D'utilisation

ASSEMBLY

FILLING/CHANGING THE WATER RESERVOIR

See Figures 15 - 16.
 Fill the water reservoir with clean tap water to the fill line.
Do not fill past the Max Fill line on the tray.
To change reservoir water:
 Unplug the saw.
 Remove the drain plug and empty waste water into a
bucket. Do not allow the water to splash onto the ground
or around the machine.
 Rinse the machine thoroughly.
 Discard the waste water in accordance with local regula-
tions.
 Replace the drain plug and refill tray with clean water.
TO CONTROL THE FLOW OF WATER
See Figure 17.
 Fill the water tray with clean water as described below.
 Locate the "Max/Min" water flow selector on the pump.
For best performance, set the flow to "Max" to control
the flow of water over the wheel.
 The pump turns on when the motor is turned on. Let the
cutting wheel build up to full speed and wait for the wheel
to get wet before moving the material into the wheel.
FILL LINE
DRAIN
PLUG
16 — English
MAX
WATER
FLOW
SELECTOR
MIN
WATER
RESERVOIR
Fig. 15
Fig. 16
Fig. 17