Dsp Functions - Sony FM Mode D'emploi

DSP functions

Problem
No sound, or sound is too low.
Error displays (when the optional CD/MD changer is connected)
The following indications will flash for about five seconds, and an alarm sound will be heard.
Display
NO Mag
NO Disc
* 1
Error
EN
* 1
Blank
PushReset
Not Ready
HighTemp
1 When an error occurs during playback of an MD or CD, the disc number of the MD or CD dose not appear in the display.
*
2
* The disc number of the disc causing the error appears in the display.
If the above-mentioned solutions do not help improve the situation, consult your nearest Sony
dealer.
30
Actual total number:
Cause/Solution
The volume of the rear speakers may have been automatically
lowered in order to maximize the effect of the listening position
adjustment.
n Press (+) to adjust the balance.
The speaker balance can be set separately for the DSP on
mode and DSP off mode (page 14).
Cause
The disc magazine is not inserted in
the CD/MD changer.
No disc is inserted in the CD/MD
changer.
A CD is dirty or inserted upside
down.* 2
An MD does not play because of some
problem.* 2
No tracks have been recorded on an
MD.* 2
The CD/MD changer cannot be
operated because of some problem.
The lid of the MD changer is open or
MDs are not inserted properly.
The ambient temperature is more than
50°C.
Sony CDX-C810DSP (E,F,G,I) 3-856-118-11 (2)
Solution
Insert the disc in the CD/MD
changer.
Insert the discs in the CD/MD
changer.
Clean or insert the CD correctly.
Insert another MD.
Play an MD with recorded tracks on
it.
Press the reset button of the unit.
Close the lid or inserted the MDs
properly.
Wait until the temperature goes down
below 50°C.