Bimar RH03B-P Notice D'instructions page 11

All packaging elements must be disposed of according to their raw material (see the symbol
stamped on each one) and according to the provisions of their municipality. The bag
containing the set of the fixing screws, which is unmarked due to its small size, therefore you
have to follow the procedures for the disposal of their municipality.
• Before installing the appliance, make sure that:
- the electrical system to which the appliance will be connected complies with current standards
and has cables whose cross-section is suitable for the absorbed power
- the voltage values on the nameplate correspond to those on the mains supply.Check that
other appliances with high absorption are not connected to the power line to avoid overloading
and fire hazards.In the event of incompatibility between the power socket and the appliance's
plug, have the plug replaced with a suitable model by a qualified professional, who should
ensure that the cable is appropriate for the power rating of the device.The use of adaptors or
extensions is generally not advisable; if it is necessary to use them, they must comply with
safety regulations and the total current (amperes) must not be rated lower than the maximum
current of the appliance.
- There are no water, gas or power lines inside the wall
- The wall to which the appliance is to be
fixed must be made of masonry and/or heat-
resistant, fire-retardant and solid material
(not wood or synthetic material), flat and free
of irregularities; the ceiling must also be
made of fire-retardant and heat-resistant
material.
- the appliance can be installed at least 2.0m
from the ground (height referred to the lower
edge of the appliance), is positioned so that
it cannot suffer impacts and that the air
outlet grid has a free space of at least 100cm,
and at least 50cm at the sides.
- the appliance is away from other sources of heat, flammable materials (curtains, upholstery,
etc.), flammable gases or explosive materials (spray cans) and materials that can be deformed
by heat.
• This appliance must not be used in any type of vehicle or restricted space (lifts, camper vans,
cars, cabins etc.).
• Ensure that the appliance is disconnected from the plug point before attaching it.
• Remove the central cover of the fixing box using the two screws, before drilling holes is good
to measure the distance between the slots above.
Attach the wall heater using the 4 screws provided, using the holes found on the back of the
casing, then position the cover again with the screws.
• Ensure that the power cable is correctly positioned and does not come into contact with hot
parts or sharp edges, or become wound around the device itself and is not twisted.
USING THE APPLIANCE
The heater is equipped with a "pull switch", to select the power output of the heater, and with
a display that shows what has been selected:
0=off 1= 500W 2= 1000W 3=1500W.
The selected modes follow on from each other by pulling the cord.
Adjust the angle of the heating part to direct the infra-red light and heat.
11