Perel EWL415T Mode D'emploi page 4


Familiarise yourself with the functions of the device before actually using it.

All modifications of the device are forbidden for safety reasons. Damage caused by user modifications
to the device is not covered by the warranty.

Only use the device for its intended purpose. All other uses may lead to short circuits, burns,
electroshocks, lamp explosion, crash, etc. Using the device in an unauthorised way will void the
warranty.

Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and
the dealer will not accept responsibility for any ensuing defects or problems.

Use the original packaging if the device is to be transported.

Keep this manual for future reference.
4. Overview
Refer to the illustrations on page 2 of this manual.
1
protective glass
2
tripod
5. Operation
General Use
1. Place your work light on a flat and stable surface.
2. Insert the power plug into the mains to switch it on.
3. Switch off after use by pulling the plug from the mains.
Mounting bracket
1. Slightly loosen the fixing knob.
2. Adjust the angle as desired.
3. Re-tighten the fixing knob.
Tripod
Refer to the illustrations on page 2 of this manual.
1. Pull the locking tab to unlock the leg and fold out the tripod leg until locked. Repeat for the other
two legs.
2. Untighten the post locks and pull the post up to the desired height. Lock the posts.
3. Unscrew the bolt on top of the post, place the bracket of the light on top of the post and fix tightly
with the bolt.
4. Proceed in reverse order to demount.
6. Cleaning and Maintenance

All screws should be tight and free of corrosion.

The housing, the visible parts, the mounting supports and the installation location (e.g. ceiling,
suspension, trussing) should not be deformed, modified or tampered with; e.g. do not drill extra
holes in mounting supports, do not change the location of the connections...

Mechanically moving parts must not show any signs of wear and tear.

If the protective glass is damaged, have it repaired immediately by a qualified technician. Do not use
the lamp with a cracked or broken protective glass.

Wipe the device regularly with a moist, lint-free cloth. Do not use alcohol or solvents.

There are no user-serviceable parts.

Contact your dealer for spare parts if necessary.
V. 02 – 20/09/2017
EWL415T
3
bracket fixing knob
4
power cord
4 ©Velleman nv