Publicité
Les langues disponibles
Les langues disponibles
1. Remove (part of) the cutlery drawer from the appliance.
STARTING THE APPLIANCE
1. Push the on/off button to start the appliance. The ready indicator goes on.
CHOOSING A PROGRAM
Note:
For an overview of the programs, refer to section
Note:
If you used an extra option with the previous program, this option will remain active for the new program.
1. Use the program selector button to choose a program. The display shows the selected program and the duration.
2. Use the timer button to delay the start time of the program. Refer to section
3. Use the extra-silent button or the half-load / extra-fast button to add an option to the selected program.
Note:
If an option is not compatible with the selected program, a buzzer sounds.
4. If necessary, cancel a selected option by pushing the button for the selected option again until the corresponding
indicator goes off.
The program starts when you close the door.
CHANGING THE PROGRAM
You can change the program while the appliance is running.
1. Carefully open the door to avoid water spillage.
2. Use the program selector button to choose another program.
3. Close the door.
The newly selected program will resume the course of the previously selected program.
DELAYING THE PROGRAM
Note:
The start time of a program can be delayed for a maximum of 19 hours.
1. Push the timer button to delay the start time of a program. Every time you push the button the timer increases by
1 hour.
2. Push the timer button again to change the time or cancel the timer.
3. Close the door to activate the timer.
The program will start when the timer has finished.
RESETTING THE PROGRAM
You can reset the program while the appliance is running.
1. Carefully open the door to avoid water spillage. The display shows the selected program.
2. Push and hold the program selector button for 3 seconds. The ready indicator flashes and the display shows 1.
3. Close the door to let the appliance drain the water inside. This takes about 30 seconds.
A buzzer sounds five times and the ready indicator is on when the program is cancelled.
'Programs'
.
'Delaying the program'
(Figure 10)
.
English
•
47
Publicité
