Garland GEISER 421 QG Manuel D'instructions page 30

English
8. DETECTION AND TROUBLESHOOTING
Problem
Engine does not start
Pump does not suction water
In case that the problem is not solved after checking this table, please take your machine to the nearest after
sales service. You can check up on these after sales services in www.recaball.com
Cause
Switch in ¨OFF¨ position
Petrol does not reach
carburettor
Carburettor dirty
Oil level low
Faulty spark plug
Insufficient compression
Air entry to the pump
Turbine damaged
30/100
Solution
Place switch in ¨ON¨ position
Check if there is petrol
in the deposit
Check that the petrol admission tube
is not blocked or folded
Take the machine to the after sales
service
Check and refill oil if necessary
Clean or replace spark plug
Take the machine to the after sales
service
Check that the hose does not have
holes through which air can enter.
Check that the racors and joints are
properly fixed and well fixed.
Joints of the racors in a bad state.
Change.
Take the machine to the after sales
service.