performance. If with the first heating the maximum temperature is not
reached, the above-mentioned effects may as well arise later on.
Open the door by raising the handle (Picture 2). If the equipment is hot, you can
use insulated gloves. Adjust the primary air regulator and the fuel switch (Picture 3)
according to the Table 1. Put coal lighter or wood wool onto the fire grate, followed
by wood chips. First insert small pieces of wood, and then larger ones, light them
and close the door again. When the wood burns quickly, and leaves sufficient
glowing embers, put additional fuel on the fire. Thereafter, adjust the primary air
regulator and the fuel switch according to the Table 1 („Adjustment of the burning
air"). The first kindling should be performed "finely" with little fuel only, so that the
parts of the fireplace be adapted to heat. During the first kindling, the generation of
smell is normal and absolutely undangerous.
1.3 Putting out of operation
•
Let the glowing ember burn to ashes and the fire-place get cold.
•
Empty the furnace chamber and the ash bin.
•
Close the doors and push the primary air regulator totally to the left.
1.4 Heating instructions
The fireplace should be operated only with closed furnace chamber door. Fire-
places belonging to type 1 have self-locking furnace chamber doors. These doors
may be opened only for kindling, loading or when cleaning the furnace chamber
(otherwise draught problems may occur with other equipment connected to the
same chimney).
When opening the furnace chamber door, any incorrect handling or insuffi-
cient draught may induce smoke. Always ensure that the furnace chamber
door may be opened only slowly, first just to a small extent, and then fully
after a few seconds. In addition, if you intend to put additional fuel into the
fire, before the opening of the door only there may be only ember bed in the
burning space, i.e. no flames may be visible.
Led into the burning space in correspondence with the existing conditions, the
secondary air provides for the follow-up burning of the combustible components of
in the burning space. This in fact means smoke and soot-poor burning, which con-
tributes to the protection of the environment. If you wish to commission the fire-
place in a transitional period, please, please first examine the chimney draught, as
it can be especially weak at high external temperatures. Towards this end, hold a
burning match in the slightly opened feeding door. If the flame is not drawn signifi-
cantly by the draught, then a so-called starting fire is to be set first. Towards this
end, burn wood chips/wool in the fireplace or the cleaning hole of the chimney. The
fire grate is to be cleaned before every kindling to ensure the proper inflow of air
for burning. The ashtray is to be emptied regularly (Figure 5). Should the equip-
ment be extremely hot, use the gloves provided. Please, be careful not to dispose
glowing materials into the waste bin.
Ensure that the ashtray should be fully pushed into the equipment.
Warning!
24